Mercury Trim/tilt-onderdeel 8M0030550

Mercury – Gen II Panel Mount Control, Finger Release, Chrome Handle | Outboard Control | 8M0030550 Overview This is the same Gen II panel mount control a lot of us have rigged over the years, just with a chrome handle instead of black. It’s a simple, mechanical control that feels solid when you grab it, not loose or lightweight. The finger release makes shifting easy when you’re creeping around docks or lining up on the trailer. It’s a good fit for trim-equipped outboards that get used the way boats are meant to be used. Key Features  • Chrome Finger Release Handle – Gives smooth, deliberate shifts with a classic look and solid feel.  • Trim Harness Included – Four foot trim harness with a three-pin Molex connector comes with the control.  • Gen II Cable Design – Built to run Gen II throttle and shift cables with proper travel and feel.  • Neutral Safety Leads – Six and a half foot leads with bullet connectors make routing easier during rigging.  • Lanyard Switch Leads – Bullet-style connectors simplify hooking up the safety lanyard switch. Engine & Boat Compatibility  • Mercury outboard engines with integral trim  • Mariner outboard engines with integral trim  • Force outboards forty horsepower and higher, nineteen ninety-three and newer  • Mechanical control systems  • Gen II control series Performance & Practical Benefits On the water, this control does exactly what you expect it to do. Shifting at idle is smooth and controlled without any harsh engagement. Trim response is quick and predictable when you’re setting the boat on plane or adjusting for chop. Once it’s adjusted right, you stop thinking about it, which is how a control should be. Why Buy OEM OEM Mercury controls are built to match Mercury cables, trim wiring, and safety switches without guesswork. Neutral safety operation stays consistent, and you’re less likely to chase small adjustment issues later. The internals also handle vibration and regular use better over time. It’s a control you install and trust to stay that way. FAQ Q1: How can I tell if this control is the right one for my boat? A: If your outboard has power trim and tilt, this is the correct style of panel mount control. Q2: What else do I need to finish the installation? A: You will need a separate ignition and choke assembly and Gen II throttle and shift cables. Q3: Does this control require any setup after install? A: There is no electronic setup, but proper cable adjustment during installation is important. Q4: Is this control okay for saltwater use? A: Yes, it’s built for marine use and holds up well with normal rinsing and care. Q5: What are common signs this control is starting to wear? A: Stiff shifting, uneven trim response, or trouble staying in neutral are typical early signs.