Mercury Kabelboom 17829A10

Mercury – Remote Control Ignition Choke Extension Harness | Wiring Extension | 84-17829A10 The Mercury Remote Control Ignition Choke Extension Harness is designed to provide additional wiring length between the helm control station and the engine. It is commonly used on larger boats, dual-station setups, or repower installations where existing ignition and choke leads do not comfortably reach. Using a proper extension harness helps maintain clean rigging and avoids stretching wiring or creating splices that can introduce stress points. Maintaining properly routed wiring supports more consistent starting and choke operation while reducing strain on connectors and terminals. Routine inspection, secure fastening, and avoiding sharp bends or pinch points can help protect the harness from chafe and vibration, supporting dependable electrical contact over time in typical marine environments. Key Features Ignition & Choke Wiring Extension – Provides added length for longer helm-to-engine wiring runs Eight-Lead Configuration – Intended for standard ignition and choke circuits in mechanical systems Marine-Grade Wiring – Designed to handle vibration, moisture, and typical engine-compartment heat OEM-Style Connectors – Supports secure electrical contact without wire modification Engine & System Compatibility Mercury outboards Mechanical remote control systems Non-ECM ignition systems Legacy two-stroke and early four-stroke Mercury platforms Important Notes Confirm engine configuration, ignition type, and connector style before ordering Route the harness away from chafe points and secure it properly Allow appropriate slack for normal movement and vibration Verify ignition and choke operation after installation FAQs 1) What is this ignition/choke extension harness used for? It extends ignition and choke wiring between the control station and the engine when additional length is required. 2) When is this harness commonly needed? It is often used on larger boats, dual-station setups, or repower installations. 3) Does this harness replace original ignition wiring? No. It is designed to extend existing ignition and choke wiring using OEM-style connectors. 4) Is cutting or splicing required for installation? No. The harness connects directly using factory-style connectors. 5) Why choose an OEM Mercury extension harness? OEM harnesses are built to Mercury wiring standards and connector specifications, helping reduce poor pin contact, corrosion-related issues, and intermittent electrical behavior.

Vervangt artikelnummers: 84-17829A10 · 93811A10. Bestel je op een oud nummer? Dan is dit het juiste huidige onderdeel.